OK, Shelby experts...help ID this intake manifold

susan parham · #1 (**permalink**) 08-15-2007, 12:37 PM

The intake is:
289/302 2X4 Cross Ram Box Intake Shelby Lettered
Finned Aluminum
Bill acquired it in a "clean out the garage" purchase.

I guess I can't fault him for not immediately recognizing the intake since it is a small block.

I would like to know the original application so I can tell my customer.

If any club members can help, I would really appreciate their input.

Thank you for your help.
Susan

CobraEd · #2 (**permalink**) 08-15-2007, 12:44 PM

Wow, THat is sharp.

Jac Mac · #3 (**permalink**) 08-15-2007, 02:01 PM

Looks like a Ford/Shelby clone of a 'Smokey Ram', nice piece, wonder if it had its beginnings around 1967/68 when I think Shelby had a bit of an interest in some Trans Am cars prior to the Boss 302 & before the rule changers obsoleted this stuff overnite.

Jac Mac

427sharpe · #4 (**permalink**) 08-15-2007, 02:13 PM

There was no otc application. It was a counter part sold as an add on by CS's parts business.

Suomien · #5 (**permalink**) 08-15-2007, 02:52 PM

Does it have the Buddy Bar casting mark on the bottom?

"Shelby" Cross Ram made by Buddy Bar for the 289 were supposedly made for Shelby for his small block drag cars...aka Dragon Snake. I think they said that they made 37 of them.

Otherwise, otc, aftermarket.

susan parham · #6 (**permalink**) 08-15-2007, 03:12 PM

Yes - Buddy Bar is cast on the bottom. Any other information/verification would be appreciated. This intake is finding a home in a GT40.