11-04-2008, 08:08 AM
|
|
CC Member
|
|
|
Join Date: Dec 2004
Location: Kansas City,
KS
Cobra Make, Engine: jbl
Posts: 2,291
|
|
Not Ranked
possibly your engine builder missed something. i would just pull the one rod and have it checked along with the rod throw diameter. be my guess since it is the same rod your clearance would be a little tight. make sure when you take it apart that the bearing chamfer is toward the outside, although i don't think it could be otherwise. rod bearing crush could be minimal also, too large on the big end to hold the bearing in place.
|
Threaded Mode
