01-06-2009, 06:33 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Jun 2007
Location: Covington,
wa
Cobra Make, Engine: Superformance # 532, 466 BB, 560HP
Posts: 3,029
|
|
Not Ranked
Quote:
Originally Posted by David Kirkham
Gents,
Ok, I finally finished the quote.
Here it is.
We can do the pins (like in the CAD drawing above) for $10 each. The cost is driven by the high cost of the raw material and the heat treating. There is quite a bit of handling involved to make a really nice part. I don't think the pins that you guys have are heat treated from what I can gather--but I would have to check the hardness on one to know for sure.
First 10 SALE:
For the first 10 CC members who purchase a set of 20 each, I will sell them for $7 each.
Now, I need to add:
We need 10 sets ordered before we can start the run so it is cost effective to do the programming, set up and first run. So, the 10 sets have to be all the SAME set! For example. 10 sets of the Trigo type with the taper on them--1/2-20 thread.
We will also extend this sale to 10 sets of the Vintage type (which from my understanding is flat--no taper--and has an M12 thread.
If I am wrong LET ME KNOW!
Production will begin after 10 sets are ordered and I confirm the angle from CNG's adapter.
David
 |
What grade of stainless material and what hardness for the heat treat?
|
Threaded Mode
