08-01-2009, 06:36 PM
|
|
CC Member
|
|
|
Join Date: Apr 2008
Location: Scottsdale,
Az
Cobra Make, Engine: Black CSX 4910, Roush 511 8 stack
Posts: 1,206
|
|
Not Ranked
Spooky or Sandy,
Since you have the same motor have either of you noticed the motor hesitating a bit after coming through a corner. Last night I had it happen twice after exiting a corner and standing on it, it hesitated/coughed a couple of times before coming back. I had a full tank of gas (it also does this if I am under a half) so I know that isn't it. The rest of the time it ran like a scalded cat. I am going to head to the pavillions tonight as I promised my 19 yr old neice a drive before she leaves tomorrow to head back home.
My water temp rarely goes above 80c and it takes a while for it to warm up. I seem to remember someone telling me the aluminum big blocks don't run near as hot as the cast iron blocks??
On a different note I know Anthem built 5 of these motors but I have never heard/seen anyone else on the forum. Do you all know who has the other 2 motors they built?
Ron
|
Threaded Mode
