|
crash pad
Hey guys,
Have been informed that I have to Have A padded crash pad on the leading edge above the dash.Does anyone know if they have to be a specific size and or can you buy them already done or do have to get them made. I have read the adr/21 but it doesn't say any sizes.Any input would be appeciated. Cheers Brett |
Impco Gas
Hi Brett, Was curious if your running propane? I noted you referenced an Impco gas feed. Sorry I don't know about the dash pad.:) Was considering running my Torino (428 CJ) on propane. Dave
|
Hi Brett,
Who is your engineer? I don't know anyone on the Central Cost who had one on their car when it got passed. Sorry I can not help you with your question as I never had to cross that bridge but it dose seem to depend what side of the bed the engineer got out of in the morning as to what he will make you comply with. Just my 2c Craig W :confused: |
Hi Brett
In vic we need a pad from passenger side.To just past the left hand side off steering wheel.Use double sided tape so you can remove after the engineer. |
Brett,
DRB in Brisbane sell them pre made for their Cobras. If you ring Peter he can probably give the specs & sell you one.They are a requirement for rego in Qld. The number is 07 38072480 Regards Nick |
Brett,
I used a section of insulation for water pipes available from hardware/plumber store. Its about 40 mm dia and already split along length so goes over dash edge real easy. Comes off easy too. Phil |
| All times are GMT -7. The time now is 10:15 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: