08-26-2007, 08:49 PM
|
|
CC Member
|
|
|
Join Date: May 2002
Location: Brisbane Australia,
QLD
Cobra Make, Engine: RMC under re-construction, GenIV with tremec 600, Jag 3.31 L/S diff
Posts: 3,318
|
|
Not Ranked
Sambo, either of the 70mm ones will do. That is either 40 or 45mm high.
The RMC is a little lower in the bodywork than say a CR so clearance is close, plus I suspect the RMC main rails are a little closer together so the engine cant sit between the rails.
There is also a drive shaft alignment issue but the dallow mounts make it way easier.
In your case with the Harrison you'd just use the mounts Warwick recommends.
__________________
It's impossible to soar like an eagle when you're surrounded by turkeys.
|
Threaded Mode
