Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Australian Cobra Club (http://www.clubcobra.com/forums/australian-cobra-club/)
-   -   KC Laser Ignition Switch Wiring (http://www.clubcobra.com/forums/australian-cobra-club/82118-kc-laser-ignition-switch-wiring.html)

macloft 09-09-2007 01:52 AM

KC Laser Ignition Switch Wiring
 
Hello Brains Trust

Can someone verify the wiring terminals on the Laser KC Ignition switch (Harrison Cobra).
There are 7 wires being Blue, Black/ White, Black/ Red, Red /Black, Black, Grey/Red, Black/ Yellow.
Thanks
Bruce

sideshow 09-09-2007 04:01 AM

blue is usually acc
black/yellow might be start
black might be battery
black white on lasers is usually ign

if u got a multi meter just put it on buzzzzzzzzzz and go thru the switches

u only need
batt in
ign
acc
and start

macloft 09-09-2007 04:33 AM

Hi Sideshow
With my meter Blue is Acc, Black/Yellow (1)+ Black/ White(2) are Ignition (2 Ignition Wires?), White(Grey)/ Red is Battery, Black/Red Start, plus 2 unknown little dia wires Black(L) + Red/Black (E) which use the same connector block.
Cheers
Bruce

sideshow 09-09-2007 04:44 AM

u dont use the small wires
u can use both ign wires depends what the rest of the body wiring has
yr multimeter wont lie

i havnt done a laser ign recently so my memory is off

another thing some ign switches have very small writing on back of switch where the wires solder on telling what the wires do

eg batt acc ign sta

so maybe check it

if u use many relays then u can probably just use only one of the ign wires

ign switches are easy to figure out

its the headlights and wiipers that cause headaches

macloft 09-09-2007 04:58 AM

Thanks Sideshow
I got my 9 year old to read the writing and we are right for the symbols.It was the 2 small wires that bugged me they have symblos L AND E. I dont think need them.
The wipers and lights are next however.%/
Cheers
Bruce

sambo 09-30-2009 04:18 AM

Dragging this thread up from the dead... Bruce, did you find out the wiper and lights wiring?

The ignition wire info checks out on my Laser column except for start. Hope the barrel isn't buggered.

I'll update the wires for column switching as I go. Wipers seem to be earth switched going by the black feed into that bunch.

Power feed - red (acc power), white/red (ignition power). Got a feeling these could be wrong...

Lights/horn - red/black (headlights with acc power), white/green (park, head lights and hi beam with ignition power), green/black, red/white.

Signals - green/red (turn feed), green/white (right), green/black (left), green/yellow (haz feed), black/yellow (haz off), blue/yellow (haz on)

Wipers - black (ground?), blue/white (wiper lo), blue/red (wiper hi), blue/orange (washer), blue/black, blue.

Things I haven't yet worked out: wiper int, wiper momentary, horn. Also the headlight logic doesn't seem right.

Sambo

sambo 09-28-2010 09:01 PM

I've worked out plenty since my last post, but last night another mystery was solved that I thought I'd share - mainly for those with late 80s KC-KE Laser columns in Harrisons.

At the back of the ignition barrel you remove a philips head screw and the ignition switch comes out as a module with 5 wires attached. The 12v battery feed on mine had become quite brittle and the insulation was going brown. Doubledip suggested I check the resistance (very high) so I pulled the switch apart to see why. The brass points and contacts were severely pitted and corroded and I'm surprised anything worked at all.

Long story short, $50 bucks later and I'll have a new aftermarket ignition switch with loom and plug. This is a common problem so anyone looking for a replacement, contact Grant Walker Parts in Melbourne on 9762-7233. It's on eBay at the moment too.


All times are GMT -7. The time now is 02:35 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: