|
Stainless Spats for Classic Revival
Does anyone know if stainless spats are available for Classic Revivals yet?
Also, have any CR guys had paint protection film (polyurethane) applied to there cars, and if so, by whom it was purchased from? I'm talking to a guy in Melbourne at the moment from Ozishield and he has done one but cannot remember the make of car. He is downloading some info later tonight to his site. Thanks. Dale. |
Dale,
Pretty sure no one has a set, but plently of people are keen! I would be interested in hearing about the coatings too. I have to keep my spray can paint job in good condition! Ben |
I have used the adhesive film until I get my vinyl spats made up (to match the tonneau). Some info was available here: http://www.clubcobra.com/forums/show...ighlight=spats
Merv |
Ozicozi
A company called surfacetech have done a few cobras now.
The company is also a sponsor of this years nationals and will have a trade stand set up on the saturday at the show and shine. Andrew is the one to talk to. Check them out at the nationals or their website. http://www.surfacetech.com.au/surfacetech/ It will be good to let them know how you found them.:D Phil |
There is a good detail on the Ozicosi product (See Phil above) in the earlier thread (also above). They have agents in each state who can supply and fit. They also have (a) Cobra template as the guy I spoke to sent me a graphic of the patterns.
It is an OK product. Merv |
I got a set of spats from finishline in Florida, but they're ally not s/steel. They need a little bit of work to finish them off but they should turn out nice. If anyones interested let me know and I'll try and post some pics.
Regards. |
Quote:
Thanks Rgds Gregg |
Hi Gregg I'll try and get some pics up tonight or tomorrow. If I can I'll get a pic of the spat on the body. Did you get the rollbar ring I put in the post?
Regards. |
Quote:
Thanks for putting up the Pics of the Spats. Yes I did get the rollbar ring. Sorry, I thought I sent you a post that I received it, apologies for not doing so. Those spats from Finishline look like they fit the CR quite ok. Are you going to silicone them on or use anything specifc to attch them? Thanks Rgds Gregg |
Gregg, they do need some work to get them right. I was planning on using a few small dobs of silicone to hold them on.
Regards. |
| All times are GMT -7. The time now is 03:26 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: