CR's body dimensions for soft top bows

Double Venom · #1 (**permalink**) 04-19-2008, 04:57 AM

Sorry to take an extra day....things happen!

Size calls for a fraction over 3/8's inch. If you do it right (not in the book) cut 6 pieces of 3/8's stainless tubing about 3"s long. Nerl the outside of the tubing, you can use a cut off wheel or even a grinder, and gouge up the outside of the tubes well. Next use marglass/duraglass, or some type of strong body puddy, cover the outside of the tubes and force them into all six holes for the bows. LEAVE about a 1/4" above the fiberglass, when hard grind off the the tubes that are sticking up above the fiberglass. Carefully! Then you can finish off the top when all the body work is being done. Don't worry about getting paint inside the now inserted tubes, when your done painting it is easy to run a dremel or the likes inside the tubes to clean and polish them. I actually drill all the way through the body holes to allow drainage.

ITAL, you do have blocks of wood glued/fiberglassed below the surface of the body/doors where the bows go-no?

I'll follow up with door measurements as soon as they are mounted.
DV

Ital-cobra · #2 (**permalink**) 04-20-2008, 04:05 AM

Hi DV
I have no wood in the doors or in the body where the bows go, should I put some? I guess this would be for support Right!

Thanks DV for your help

Double Venom · #3 (**permalink**) 04-20-2008, 05:32 AM

Ital-
Was your body made in Canada? SHAME ON THEM FOR NOT PUTTING IN THE WOOD BLOCKS! Yes, definately glue-fiberglass some wood blocks in. These are what will remove the stress of the top and window bows pulling against the fiberglass. about 2"s wide, 3"'s long and 3"s deep. Measurements are not exact but this will give you an idea. Once you have the door inside panels cut out they are pretty easy to do. The two on the rear body are the tougher ones, but they will go in, just do not glue in the rear wheel tubs until the body is being mounted and the wood blocks are installed.
DV

Ital-cobra · #4 (**permalink**) 04-20-2008, 06:16 AM

thanks DV for your help

Ital-cobra · #5 (**permalink**) 04-20-2008, 06:51 AM

DV my body came from Bill Emerson I dont think he use's tops in his neck of the woods

Double Venom · #6 (**permalink**) 04-20-2008, 07:50 AM

Hmmmm,
I'll have to talk to Bill about this!
DV
PS. Do you understand the info./measurements except for the doors of course?