04-18-2013, 01:41 AM
|
|
CC Member
|
|
|
Join Date: Sep 2012
Location: Portland,
OR
Cobra Make, Engine: ERA - B2Motorsports Dart 331
Posts: 464
|
|
Not Ranked
Roll Bar End Links
Bob - The front end links on my car seem long. The bar is at quite an angle relative to the lower control arm. I would like to run the ba, parallel to the lower control arm. I mocked it up and it leaves about 2 5/16 between the bar mount and arm mount when both are parallel to ground. I have a blown shock mounted with no spring and I can fully cycle it. The bar appears to articulate with no binding within the shock travel. I threw a mounted tire up there as a sanity check and it all looks good.
I want to run rod ends. It looks like it will work - compact, but doable.
Am I missing something?
Side note - I threw a front lower control arm on a CMM and ended up with a .96 motion ration. Got some leverage out there. 
Very nice and thank you. 
Last edited by ERA2076; 04-18-2013 at 01:46 AM..
Reason: Clarification
|
Threaded Mode
