05-10-2014, 07:13 AM
|
 |
CC Member
|
|
|
Join Date: Nov 2007
Location: Clayton,
IN
Cobra Make, Engine: ERA 838
Posts: 1,133
|
|
Not Ranked
Sun visor screw spacing on windshield
I have had ERA 755 for almost 4 years. When I purchased from the original owner the sun visors weren't installed.
The car looks clean without them, but I decided to install them yesterday to see if it helps redirect some of the wind.
The brackets that mount to the windshield frame have a significantly different hole spacing than the windshield frame (estimated .100" difference). Are there two or more hole configurations for the visor brackets? Where would I get the other version? Or, I can make my own if I have to?
Bob - Do you sell just the brackets? Do you happen to have prints for the two versions of brackets? It is helpful to have the exact spacing so that I can use an end mill to drill the holes and get them exact.
A few years back, Bob supplied prints for the soft top windshield mounting brackets. There were two bolt spacing options. I bet the visors are the same.
John
|
Threaded Mode
