05-06-2018, 06:48 PM
|
 |
CC Member
|
|
|
Join Date: Aug 2013
Location: Canandaigua,
NY
Cobra Make, Engine: SPF MKII Riverside Racer FIA
Posts: 2,507
|
|
Not Ranked
Quote:
Originally Posted by DanEC
Jim - this breather appears to have some sort of sintered metal filter in it - sort of like those factory Holley fuel inlet filters I think. Also, the vent passage on this is under the hex head so I don't think hooking a hose up to it would work very well. I'll keep an eye on it but I hope that filter media will hold down the possibility of oil spray making it's way out. If it gives me any trouble I might have to replace it with a pipe thread nipple that I can slip a piece of rubber hose on to, and extend that up by the engine and put the vent in the end of it. |
Dan,
Mine was on the the tail housing as well and you are right, if you have to do a vent hose you will have to replace the breather with a pipe thread nipple, that is what I had to do. Good luck and hope everything goes well.
Jim
__________________
|
10Likes
Threaded Mode
