08-30-2018, 01:04 PM
|
|
CC Member
|
|
|
Join Date: Dec 2012
Cobra Make, Engine:
Posts: 973
|
|
Not Ranked
I've been in your shoes before. I had to take a dremel and carefully sand away the portion of the dash (backside) to recess it enough to hold the nut down on the front. I found a way to do this on my installed dash by putting a sanding disk backwards on the the dremel after I pushed the dremel through the hole and then apply a pulling pressure as I sanded away material on the backside.
__________________
|
1Likes
Threaded Mode
