03-20-2007, 08:38 PM
|
 |
CC Member
|
|
|
Join Date: Jul 2005
Location: Tulsa,
ok
Cobra Make, Engine: Lonestar, 427 Center Oiler
Posts: 352
|
|
Not Ranked
Cylinder wall question
I just took my pan off to replace it w/ a Canton road race pan. I saw the casing numbers and didn't find anything too exciting. Looks like a 63 block, cast crank. No sleeves in the cylinders. It does have Ross XL 425 pistons, not sure if that means anything. I really don't know much about the internals of the engine since I didn't build it.
My question is that I can still see all the crosshatching on the cylinder walls. Is this good or normal? The car has 6500 miles and I believe it was a newly assembled engine at that point.
Mat
|
Threaded Mode
