
01-29-2021, 11:56 AM
|
 |
CC Member
|
|
|
Join Date: Feb 2006
Location: Thousand Oaks,
CA
Cobra Make, Engine: Classic Roadster
Posts: 1,369
|
|
Not Ranked
Sledge,
The screws have an interference fit...Someone on the FE forum mentioned they are peened (not sure what that means). I assume so they don't vibrate loose and get sucked in and processed through the combustion magic. Only loosen maybe 1/4 turn, set idle adjustment as low as it will go. Tighten and readjust the idle position screw. I was getting a weird hang up with the engine running, but with the engine off no hang up. Maybe vacuum was pulling the butterfly plates closed where the friction occurred. I hope it helps you.
John
|