10-07-2011, 10:53 AM
|
|
Senior Club Cobra Member
|
|
|
Join Date: May 2006
Location: Manteca,
Ca.
Cobra Make, Engine: None, sold it
Posts: 2,439
|
|
Not Ranked
ProComp distributer
I have a bit of an issue with my ProComp distributer. I know, throw it away and buy a quality one. I might when this one craps out.
Anyway, there is a pin in the top of the housing that I believe is intended to lock the cap in position. This pin either broke or slipped down into the housing so the cap can rotate/move. Does anyone know if there is a special pin that ProComp uses? The reason that I am asking is because the hole in the distributer is round (looks like it just had a 1/8" roll pin in it) but the corresponding location in the cap looks to be a rectangle shape, approximately 3/32 wide.
There is a gouge in the cap where the pin had aligned before. It looks as if they were trying to put an 1/8" round roll pin into a 3/32 wide rectangular slot. Now, not being a physics genius, this just does not seem quite correct.
Thanks in advance for the razzing on the ProComp electronics  .
__________________
Terry
"I may be paranoid, but that doesn't mean they are not watching me"
|
Threaded Mode
