Club Cobra

Club Cobra (http://www.clubcobra.com/forums/)
-   Midstates Cobra's---Speak with Bob Kallio (http://www.clubcobra.com/forums/midstates-cobras-speak-bob-kallio/)
-   -   Mid-States question ????? (http://www.clubcobra.com/forums/midstates-cobras-speak-bob-kallio/64993-mid-states-question.html)

wicked fast 06-02-2005 12:03 PM
Mid-States question ?????
 
Hey.

Trying to mount the slave cylinder to the
round tube frame.
Their are no mounting holes from the factory.

Does anyone have a picture of how
it is attached to the frame ??

Thanks,
BC

blykins 06-02-2005 12:07 PM
You will either have to fab a bracket to hang off of the tranny mount....or make a bracket to hang off the frame rail. I did the latter with my SV. It's a box frame, but it's the same concept. I took a piece of solid round bar....drilled it and tapped it for the bolt that goes through the slave cylinder rod bearing.....and welded it to the frame rail.

427 S/O 06-02-2005 01:09 PM
See my pics...........

Roxie_427 06-02-2005 05:44 PM
FinishLine sells a slave cylinder kit which mounts the cylinder on a bracket and the bracket to the block/bellhousing interface. It's clean and compact. It's also $175.

I didn't purchase the kit, but I duplicated it with some 1/4" flat stock, a slave cylinder from NAPA, and an afternoon of cutting, shaping, and fitting. Total cost was about $75, including stainless fasteners.

Instead of the mockup drill bit you see here, I purchased a CNC pushrod ($13, I think) and cut it down to size.

Tim

http://www.welovecritters.com/DSC_1381.JPG
http://www.welovecritters.com/DSC_1387.JPG

zipzip 06-03-2005 08:29 AM
1 Attachment(s)
I took this pic off of a Midstates car - this is how they do it.

For mine, I fabbed a "Z" shaped bracket that came off of the rear engine mount bolt. With a couple of triangular webs on each side, I mounted the cylinder through one of them. I'll upload a pic of what I have tonite.


All times are GMT -7. The time now is 07:17 PM.

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: