06-13-2015, 07:20 AM
|
|
CC Member
|
|
|
Join Date: Mar 2009
Location: Mendota,
IL
Cobra Make, Engine:
Posts: 697
|
|
Not Ranked
Hi Larry What I am getting at is how do you know the jig you are using is an accurate jig of an original. There will be problems in just building a jig accurately when welding it together . Most people would be shocked to see how much a weld can pull a joint when lets say a piece of tube gets welded on one end and the other end is 3 foot away. I have seen where a part was jigged up and welded and after the part was taken out of the jig it is imposable to put back in the jig. I would think that the original cars chassis varied from car to car for this reason alone. If the jig was built off of an original car how does anyone know that that car didn't have a crash in the past and have small twists and bends that cant be seen?
Mark
|
6Likes
Threaded Mode
