|
brakes for CSX4000?
good day,
can anybody tell me please which brake calipers and rotors are used on the current CSX4000 cars? I will check my drawings tomorrow for mounting points. rears are 2.68" apart on a 6.4" diameter? front: what diameter are the rotors? I will use 6-pin wheels. dominik |
Their flyer says Baer 2 pistons with 4 pistons being an option.
|
thanks,
I am still waiting for a reply tomy email from BEAR. dom |
good morning,
BEAR replied, having no brakes for a CSX4000, or replica with 6-pin wheels. next try: BREMBO dominik |
Dominik,
Are you looking for specific part numbers? The rotors are slightly under 12". I believe they are 11.19". The calipers are made by PBR. I remember buying a set of pads for a 4000 car, and the application we told the parts guy was a mid 90's Corvette or Camaro. Baer uses them for a lot of their brake kits If you want part numbers off the calipers, I'll try and look at a set for you and get photos. |
thanks Kris,
part numbers would be fine. of course I can adapt a lot and make rotor hats, but I am a litle tired of that. plus straigth bolt on brakes look so much better than adapted ones. cheers, dominik |
I upgraded the brakes on CSX4083 from the original Girling to Brembo race brakes. I will sell the original Girlings brakes, calipers and rotors, they have about 500 miles on them.
Alan J Sorkey Shreveport, LA asorkey@hotmail.com |
good morning,
I found the GIRLING numbers in the owner's manual and looked up the bolt spacing tomount the calipers to my uprights: 5 1/8" front (13mm hole) and 2 11/16" rear (7/16" NF thread). would the original GIRLING fit to those? cheers, dominik |
| All times are GMT -7. The time now is 02:53 PM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: