10-23-2009, 06:57 PM
|
|
Club Cobra Member
|
|
|
Join Date: Jul 2002
Location: Huntington Beach, CA,
CA
Cobra Make, Engine: Kirkham 482 ci alum block
Posts: 250
|
|
Not Ranked
Patrick,
I have been following your build for quite some time and I am amazed at your ability's with your manufacturing skills. I am a active owner in a fairly large manufacturing company with a very good CNC department and you do things we might not want to tackle.
I used the same gauges on my JBL car and was very happy with quality of the gauges. The only thing I would like to suggest that what every you cover the dash with, consider adding a 20 degree angle ( or somthing close) to the gauges so that they face the drive seat. These gauges have a large bevel ring and by adding the angle you can read the gauges much easier form the drive seat.
Just a suggestion from someone that has used these gauges.
David
|
3Likes
Threaded Mode
