Body Buck

[jberg]

63Mercury: You may say in your family reunion that you will now concentrate to body building ;-) That is healthier hobby that old cars....or maybe not.


I sent you one e-mail and there are those DWG-drawings for plywood parts (what is visible in body buck thumbnail in my earlier message). And thanks again for yours drawings.

If someone else here like to have these just PM to me. Zip-file size is 1.5Mb so I can't post that to here so I need some e-mail address where to send that. Those are still draft but prize 0$ isn't bad so prize/quality should be in balance. And there is a lot of manual work left if use those but those are at least start point.

All info of chassis drawings and specially origin (or what are designed to fit to origin chassis) suspension parts dimensions, source etc info could be nice to get because I will really need those.


Is that 46" correct distance?

I have about same in my design but I think that each (name for that place..."flat circle") diameter is larger in my design. What should be diameter for that "flat circle" where head light will be mounted? I use guestimation 7"light+1" addition frame around that in body. That additional frame have some "1/2" fillet radius" (at least those who use Cad know what I mean...), but I think that this additional area is too much. Could somebody say that what is correct size for that circle?