02-17-2003, 11:10 AM
|
 |
CC Member
|
|
|
Join Date: Mar 2000
Location: Dayton,
OH
Cobra Make, Engine: RCR SLC, Graziano 6-spd, LS3
Posts: 914
|
|
Not Ranked
Eastwood engine turning kit
I've seen some very nice looking engine turned dashes and panels on hot rods at car shows, and thought I'd give engine turning a try. So, I ordered a kit from Eastwood. Just thought I'd share the results.
I made a gauge pod that will go in the center of the dash, and a switch panel that will be below the gauge pod. For the gauge pod, I used a piece of stainless steel sheet, and the switch panel is aluminum.
Gauge pod:
Switch Panel:
Pete |
Threaded Mode
