Question about TREMEC 3550

ScottG · #1 (**permalink**) 05-22-2003, 01:18 AM

I replaced the rubber shift boot on my SPF with a new one, and now the damn thing keeps popping out of gear when I let off the throttle or push in the clutch.

I know its the new boot, so any suggestions. The new one came from SPF, and while it is quite a bit stiffer than the old one, its not excessive. I didn't see where there is any way to adjust this.

TIA
Scott

Wade Chamberlain · #2 (**permalink**) 05-22-2003, 05:12 AM

Scott - I had the same problem when I switched from a T5 to a 3550. The shifter location was only slightly different, but it was enough that the boot would push it out of gear. I ended up going with a leather boot instead of the rubber one. Problem solved.

Mr.Fixit · #3 (**permalink**) 05-22-2003, 10:45 AM

The boot needs to be centered better. It is shifted in one direction probubly. Also, the accordian folds sometimes stick together after being in a bag for a long time, pull the center of the rubber up and make sure the folds aren't stuck together.

Roscoe · #4 (**permalink**) 05-22-2003, 12:37 PM

OR, get the Pro 5.0 shifter. This is a much shorter throw shifter and it will eliminate the problem. I know it's and expensive remedy but it is worth every penny cause the trans shifts 100% better. If you order it direct from them you can eliminate their shifter handle and save 35 bucks.
http://www.pro-50.com/
Roscoe

Chaplin · #5 (**permalink**) 05-22-2003, 01:22 PM

Roscoe-
I forgot to tell you- remember the discussion we had about the plastic cup that was on the ball of stock shifter- I called Pro 5.0 and they said that you are supposed to re-use it on the new shifter.

Mike