11-03-2003, 12:37 PM
|
 |
CC Member
|
|
|
Join Date: Mar 2000
Location: Fairfield, NJ, USA,
NJ
Cobra Make, Engine: A & C, 351W, Tremec 3550. Exiled Member: Club Cranky
Posts: 5,897
|
|
Not Ranked
Oil Pressure Grounding Problem
I recently re-plumbed my Accusump pre-oiler to flow directly into the port on the block previously occupied by the pressure sender. I used all aluminum AN fittings and placed one of those pressure gauge adapters commonly used for fuel pressure gauges (union at both ends). I could not get the gauge to work and figured out it was all that aluminum. To solve the problem I used a stainless hose clamp around the sender with one of those connector tabs. I ran a ground from that to the chassis and it works perfectly.
Roscoe
__________________
Roscoe
"Crisis occurs when women and cattle get excited!"....James Thurber
|
Threaded Mode
