12-17-2006, 07:10 PM
|
|
Club Cobra Member
|
|
|
Join Date: Sep 2002
Location: FLORENCE, AL,
AL
Cobra Make, Engine: Hurricane Cobra - Keith Craft 428 stoker, 600 HP/614 Trq
Posts: 71
|
|
Not Ranked
sidepipe seal
I have headers that slip into my sidepipes. So far I have not been able to get them to seal properly. I have cleaned both sides of the pipes on the headers and the side pipes and used Permatex Ultra Copper in a quarter inch thick ring. I put the ring about one quater inch from where the headers bottom out slipping into the sidepipes (four into four pipes). I allowed the seal to set up for about 24 hours.
Is there a better application method? Should I be using a different product?
I am open for suggestions.
Thanks for the help in advance.
Coach Mike
|
Threaded Mode
