|
Question for SPF owners with 351W+
I'm putting the finishing touches on my SPF #1649. I'm to the point where I'm connecting water hoses, and am working on the hose that connects the upper port of the water pump (5/8" hose fitting) to the port on the neck of the "header" or "puke tank" (looks like 3/4" hose fitting). The port sizes are different. The angles are a bear!
The water pump I was sent as part of the install kit is a Carter with fixed hose connections. The hose they sent as part of the install kit is 3/4" on each end, and looks like crap when mounted. What are you guys using for a solution to this? Please post pictures if possible. Thanks! Ray |
SPF PROBLEM
Ray, the best advice I can give you is to contact the Olthoff's in NC ( Superformance Dealer) for the best way to accomplish your install; and the proper way in case you decide to use your car for any track events. There is a difference!!!!
Also, Second Strike website may offer some help. All dealers are listed there. TL:MECOOL: |
Well....obviously didn't get much response here, so I came up with my own solution. I replaced the Carter water pump that came with the install kit with an Edelbrock waterpump that had threaded water ports (3/8" threads). I used a straight fitting for the lower hose to the heater control valve, and a 90 degree fitting for the water by-pass to the neck. I then went to my local AutoZone and found a hose with the tightest "U" I could find and a 5/8" on one end and 3/4" on the other. The clearances are tight, but it fits perfectly and looks excellent!
|
:D No duct tape?:D
:LOL: :LOL: :LOL: :LOL: Ray, I'm really surprised you didn't get any responces. Where are the "Gasholes" when you need 'em :confused: TL :MECOOL: |
I almost forgot I asked this question. As it turns out, I replaced the stock type waterpump with an Edelbrock unit. The stock pump had fixed hose connections, the Edelbrock has threaded fittings. so I was able to use a 90degree fitting for the water pump hose to the intake, and although the clearances were fairly close, it fits GREAT! Really looks like it should! I just used a short U shaped hose for the connection. If anyone else is facing this problem, I'll email a photo.
|
| All times are GMT -7. The time now is 09:59 AM. |
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: