Leaking intake gaskets

[Rwillia4]

How much room is there between the two metal surfaces? On mine there was 3/16" of space so I used a metal spacer to make the distance smaller so the gasket would not bulge out.

[onefastmustang]

Originally Posted by Rwillia4

How much room is there between the two metal surfaces? On mine there was 3/16" of space so I used a metal spacer to make the distance smaller so the gasket would not bulge out.

I think that is part of my problem. I think there is more space between the intake and the top of the block than the cork allows.

So far I have tried

Cork alone - failed
Right stuff 1 minute - Failed - blew out and oil seeped past the top of it.
cork and right stuff (sat over night) - Oil seeped out past the top of the right stuff.

Looking for more suggestions or someone that would like to make a lot of money off me to make this go away..