09-17-2016, 06:11 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Dec 2001
Location: Shasta Lake,
CA
Cobra Make, Engine:
Posts: 26,618
|
|
Not Ranked
The 6 pound lead hammer from the link in the above post is what I have always used. I just wrap an old rag around the spinners ears and have never had a problem. I do use the spinner take off tool to help loosen them but that is just for taking them off. I only tighten them until they are good and snug and use the anti seize on them. Then I put the safety wire back on.
Ron
|
9Likes
Threaded Mode
