08-11-2008, 07:05 PM
|
|
CC Member
|
|
|
Join Date: Dec 2001
Location: Louisville,
KY
Cobra Make, Engine: I'm Cobra-less!
Posts: 9,417
|
|
Not Ranked
That's not really a large cam. The lift isn't much at all....but of course if your pistons don't have enough piston/valve clearance, it doesn't matter how much lift you have. Did you check piston/valve clearance when you installed?
One thing that you haven't mentioned is whether or not the cam is a roller or flat tappet cam.
If it's a roller, that will eliminate the idea of the cam going flat.
If it's a flat tappet, I would put a dial indicator on a lobe and see if you still have the lift that you should have.
|
Threaded Mode
