
04-21-2002, 05:50 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Aug 1999
Location: Carlsbad,
CA
Cobra Make, Engine: Previous owner of SPF#1938, with a Keith Craft 496ci Genesis 427 side oiler, 667 FWHP, 633 FWTQ, 560 RWHP, 550 RWTQ.
Posts: 1,303
|
|
Not Ranked
Lucas lights
Todd,
I think the problem might be the color coding on the wires on the Lucas headlights. Check which color wire you have as ground. On the Lucas lights, ground is green.
The "I" on the regulator is the excitor if my memory serves me correctly. As long as you have done the wiring as shown in the Painless instructions, you're OK.
As far as the horn goes, I'm a bit stumped there. The horn wire on the Painless kit is the green # 924 and should go to the horn. As you said, the other side of the horn circuit goes to ground. The horn wire comes from a relay, but I would think if the fuse were removed the horn would'nt work. Are you sure you pulled the right fuse? Check again, just to be sure.
Jim 
Last edited by jwoodard; 04-22-2002 at 04:52 PM..
|