| John Martin |
09-29-2010 02:02 PM |
Top loader / 3 shifter shafts leak on side of case .
Is there a simpe way to pull the shifter shafts out enough to change the rubber rings . I have it one the work bench with the top off . It looks to me if I took the bolt out behind the rail that attach the shafts to out , it may allow for that shaft to come out . Thanks !
|
| blykins |
09-29-2010 02:42 PM |
If you're talking about the little shifter shafts on the side, no....you about have to take the whole trans apart to get those out. They install from the inside.
|
| John Martin |
09-29-2010 06:15 PM |
Does the rod inside that holds them together come out the back by the tail piece .Thanks !
|
| blykins |
09-29-2010 06:18 PM |
It's been awhile since I've been in a Toploader, but I think 2 of the 3 come out the rear.
|
| blykins |
09-29-2010 06:20 PM |
1 Attachment(s)
This picture should shine a little light...
|
| sfm8s191 |
09-29-2010 06:23 PM |
hi john if i recall the rods do come out the back after the tail shaft is removed..the rods have set screws on the forks as you can see,and the rods have a series of detents and springs in the top and behind the bolt in between the shift bosse out side...sound confusing?? they are stops for shifter fork movement ,and also a reverse lockout so you dont go in between gears ...
|
| Excaliber |
09-29-2010 08:48 PM |
Gotta watch out for that dang reverse lockout pin, it wants to fall out of place just when your ready to reassemble. Trans will shift fine, mostly, until one day it decides to hang up between 1st and reverse and lock the linkage tight. THATS when you eventually figure out the reverse pin fell out...
I know this for a fact. :)
|
| John Martin |
09-30-2010 06:51 PM |
Thanks , the last time the trans was out , I had a synchromesh on 2nd changed . I was watching the guy take it apart . I think I will wait until something needs fixing inside .
|
| All times are GMT -7. The time now is 04:17 AM. |
|
Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link:
