10-14-2010, 06:34 PM
|
 |
CC Member
|
|
|
Join Date: Oct 2010
Location: Clovis,
CA
Cobra Make, Engine:
Posts: 10
|
|
Not Ranked
Webber Transition Ports
Instead of drilling a third hole, has anybody tried opening up the original two holes to equal the volume of three as if the third hole was added? This would eliminate the need for a jig. It seems that this could be done on the car by coating the drill bit with some sticky grease to capture the chips. I think that any of the very small chips that happen to enter the cylinders would be vaporized with no damage being done. What do you think?
|
Threaded Mode
