Robert Sobers
Wed November 9, 2005 10:36am
|
Power Plant
D.S.S. Pro Bullet 306/308 Short Block Level 10 CNC
Rods: Forgings, shot-peened, Magna Fluxed, CNC Diamond resized and fitted with ARP Wave Loc rod bolts. Balanced to racing tolerances.
Crank: Production crankshaft, thermal cleaned, shot-peened, Magna Fluxed, precision ground, oil scooped and chamfered and balanced to racing tolerances.
Pistons: DSS PRO-LITE Forged 2 valve relief flat top, CNC fly-cut for most aftermarket race cams and heads. Balanced to racing tolerances.
Rings: Sealed Power/ Speed-Pro Moly rings.
Bearings: Tri-metal rod and main bearings.
Block: 5.0 roller cam block, thermal cleaned, stress relieved, Magna Fluxed, threads chased, mains checked and corrected, oil galleys tapped for thread in plugs and the decks are CBN squared and equalized.
|
|
trs900
Wed July 26, 2006 12:35pm
Rating: 10
|
Pad built using dirt from pond
!5 ft high from original ground level
|
|
Morris
Thu November 16, 2006 7:10pm
|
Rollover valve and Fuel Level sender
|
|
Morris
Thu November 16, 2006 7:10pm
|
Fuel Level Sender in tank
|
|
JAC
Wed July 11, 2007 6:05pm
|
pipes
measured floor to flange both sides the same.
front of frame to flange-same,
outer edge of frame to flange-same.
both side pipes level and parallel to frame and floor. Gap at rear of driver side flange.
|
|
MrMagoo
Sun November 25, 2007 10:26am
|
Engine Removal (1)
Leveler is "a good thing"
|
|
RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
Bernica
Wed February 25, 2009 12:15pm
Rating: 10
|
IMG_2618_Medium_
Added fuel level gauge (on right)
|
|
Rebel1
Thu May 14, 2009 4:30am
|
|
mickmate
Mon August 17, 2009 4:07am
Rating: 10
|
Dash HiTech
Fuel pressure and level
|
|
Dwight
Sun October 17, 2010 6:19am
|
oil pan, oil level
oil pan, oil level
|
|
nanard289
Fri December 30, 2011 2:23pm
Rating: 9
|
Carbs front view
In this picture, we can see the vertical angle of 5°. In this position, we have to decrease by 1mm fuel bowl level in the carbs
|
|
sinkers46
Fri April 11, 2014 10:20pm
|
First step in Cobra build.
Footings done ground leveled.
|
|
Dan Case
Mon March 11, 2019 1:56pm
Rating: 10
|
427 Cobra carburetor leveling spacer
|
|
eschaider
Sun November 28, 2021 1:57pm
|
Mobil 1 Zinc Levels
Mobil 1 Zinc Levels
|
|
