Baz
Thu May 28, 2009 9:34pm
Rating: 1
|
Colour_on_at_last_Small_
First coat went on yesterday. The colour is from VZ Monaro & known as Turismo with additional Pearl. Now the stripes, clear and flow coat and it should be out of the painters next week.
|
|
sambo
Mon June 1, 2009 7:30pm
|
R33/S15 axles
S15 shafts on the outside
|
|
martrogers
Fri June 12, 2009 3:03am
Rating: 5.5
|
Insulation over cat
Insulation to keep out the heat of the cat convertor below
|
|
DocDirk
Fri June 19, 2009 9:49pm
|
Heading out for a helicopter tour of Grand Canyon
My son Preston posed for this shot.
|
|
63mercury
Sat June 20, 2009 7:22pm
|
footbox
Making it out of cardboard is much cheaper than aluminum for the first pattern.
|
|
392cobra
Thu July 9, 2009 3:45pm
Rating: 10
|
|
acecob
Mon July 20, 2009 4:31am
|
Ready for another outing FOSC
|
|
acecob
Mon July 20, 2009 4:31am
|
Ready for another outing FOSC
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 10
|
ERA 289 FIA shoulder harness mount
Roll bar mount for raising the shoulder harness. Moved one of the belt anchors to the outside of the roll bar. For the inside anchor I welded a bracket on the bar. Point was to be symmetrical to where I mounted the seat. Did not mount the seat as suggested in the "offset" position. Wanted it directly back from the pedals. Did lose some leg room by not doing the normal "offset".
|
|
Pete Munroe
Wed July 22, 2009 9:58pm
Rating: 6
|
Canton oil thermostat
ERA 289 FIA with Canton oil thermostat. This is the drivers side hose run to the cooler.
Off-set the Canton thermostat cooler line outlets by taking it apart and rotating the segments. The segments can "clocked" in 90 degree increments, so the oil cooler hoses can exit on opposing sides. Made plumbing a lot easier in this installation. Fewer angles in the swivel fittings helps avoid any restriction on oil pressure.
|
|
Wbulk
Thu July 30, 2009 12:56pm
Rating: 10
|
Kirkham Alternator Bracket on a B and B
Reasonably priced bracket that allows the alternator to be mounted between the frame and out of the way of the upper hose. I think I paid $50 from Kirkham Motorsports.
|
|
jcraigau
Mon August 17, 2009 4:52am
Rating: 10
|
LS1 coming out party
LS1 coming out party
|
|
cobrasnake
Tue August 25, 2009 9:44pm
Rating: 10
|
Club Auto Sport
Sales Showroom
Check out the 300SL in the rear
|
|
cobrasnake
Tue August 25, 2009 9:44pm
Rating: 10
|
Club Auto Sport
Cars outside condo roll up doors
|
|
KCKingCobra
Tue September 1, 2009 1:46pm
|
Nile Car Show
Check Out the Logo on Her Shirt
|
|
