simon clemens
Sun April 3, 2005 7:53am
|
Hood Pull
Bracket made to mount '82'Corolla boot lock. Bracket will be fibre glassed to the firewall.
|
|
simon clemens
Mon April 11, 2005 5:07am
|
Rear end
Diff housing is shortened, & is waiting for coilover brackets to be welded into place.
|
|
simon clemens
Mon April 18, 2005 4:52am
|
Diff Brackets All Tacked
Suspension Brackets all tacked in position.
Lower shock brackets have 3 position height adjustment, this will make it easier to set a good ride height.
|
|
simon clemens
Wed April 27, 2005 7:00am
|
3 Position Height Bracket
3 Position suspension height bracket on lower coilover eyelet.
12 Position dampen rate on 'QA1' shock. Plus adjustable spring tension.
Shortened BW Diff.
New 28 spline axles.
New 3.73:1 gear set.
New 4 pinion LSD assembly.
|
|
simon clemens
Wed April 27, 2005 7:00am
|
LHS Axle, 'QA1' Coilover
Shortened BW Diff.
New 28 spline axles.
New 3.73:1 gear set.
New 4 pinion LSD assembly.
3 Position suspension height bracket on lower coilover eyelet.
12 Position dampen rate on 'QA1' shock. Plus adjustable spring tension.
|
|
simon clemens
Wed April 27, 2005 7:24am
|
Brake relocation
Rear brake relocation was needed to allow clearance between the coilovers and the calipers. Re-drilled calliper mount bracket holes so the caliper sits about 40 degrees foward from original position. Also had to swap Left & Right brake assemblys to opposite sides, so the hand brake cable now will run on top of the axle & still be accuated by a foward movement. I wonder if others have thought of this solution?
|
|
W2zero
Sat May 14, 2005 8:14pm
|
Roll control
Gotta stage this hummer some time. Homeyfab bracketry.
|
|
W2zero
Sat May 14, 2005 8:14pm
|
Sick bracket
Too much free time. Combo return spring anchor, throttle valve cable stop, fuel line bracket. Stainless too!
|
|
nanard289
Mon May 23, 2005 12:29pm
|
Filter bracket
A common bracket for oil and fuel filter
|
|
alfy65
Wed June 15, 2005 6:57pm
Rating: 10
|
|
Naumoff
Sun July 10, 2005 5:11pm
Rating: 10
|
filter and bracket before sand blasting
|
|
Scott S
Sun August 14, 2005 2:26pm
|
DSC00012
Coupe Rear Shock Brackets
|
|
simon clemens
Mon September 12, 2005 4:07am
|
Side Vent
Finish Line, Vents.
Made right angled aluminium brackets, and tapped them with a 6mm thread, so the vents could be bolted secure with stainless steel domed cap-screws.
|
|
ERA Tom
Sat October 8, 2005 4:22am
Rating: 10
|
P2250133
return spring bracket view
|
|
jerry w
Sun October 30, 2005 5:28pm
Rating: 10
|
|
