cobrajeff
Sun November 21, 2004 12:06pm
Rating: 10
|
Weber intakes
My new SVO intake on right, after milling "Hall Pantera" out of the valley, and adding a rear stud for new linkage.
|
|
cobrajeff
Sun November 21, 2004 12:08pm
Rating: 10
|
351C Weber intakes
High-Port manifold on right. Note vacuum holes on inboard side, as opposed to th eold intake, where they were outboard.
Two bosses on intake for "hard" linkage, as opposed to th e"cable" linkage of the Pantera system.
|
|
cobrajeff
Sun November 21, 2004 12:11pm
Rating: 10
|
Weber intake
Vacuum lines on modified 351C Weber intake. One port in front for distributor, one in back for automatic tranny.
|
|
cobrajeff
Sun November 21, 2004 12:28pm
Rating: 10
|
Weber linkage
Weber "hard" linkage for system with carbs facing opposite each other (unfinished).
|
|
cobrajeff
Sun November 21, 2004 12:30pm
Rating: 10
|
Weber linkage
Splined shaft from Enderle Injection for Weber "hard linkage".
|
|
computerworks
Sat January 1, 2005 6:50pm
Rating: 10
|
|
cobrajeff
Sun January 2, 2005 1:16pm
Rating: 10
|
Weber intake
Note the pads under carbs have been reduced 1/4" to increase hood clearance.
|
|
cobrajeff
Sun January 2, 2005 1:16pm
Rating: 10
|
Webs2
Here is what the Webers looked like on my 351C - poking thru the hood. I milled 1/4" off the top of the manifold to increase clearance.
|
|
cobrajeff
Wed February 23, 2005 4:49pm
Rating: 10
|
Spare engine
My aluminum 351C - backup engine for my ERA FIA.
|
|
cobrajeff
Wed February 23, 2005 4:50pm
Rating: 10
|
Trans Am 351
All aluminum 351 Cleveland. SK block, reportedly from Trans-Am racing series, Ford Motorsport "hi-port" alloy B3 heads, Hall Pantera Weber intake, 48 IDA's.
|
|
Full Throttle Al
Wed March 9, 2005 6:38am
Rating: 10
|
Small Block Weber setup
Brand new 48IDA Weber small block setup on Cobra manifold. Everything polished and chromed, never used, show quality from Inglese Induction.
|
|
traindriver
Fri March 18, 2005 7:07pm
Rating: 10
|
|
nanard289
Mon May 23, 2005 11:54am
|
Fuel manifold/filter
Combination of fuel filter and manifold to supply the Webers
|
|
nanard289
Mon May 23, 2005 12:12pm
|
Weber intake modification step 1
is not easy to adapt Weber carbs on Yates head cylinders. I have first cutted a Roush intake manifold to have the Yates basement
|
|
nanard289
Mon May 23, 2005 12:20pm
|
Weber intake modification step 2
After step 1 completion, you have to find an old 351Cleveland weber manifold (from a panthera or other) and to cut the top parts
|
|
