speed220mph
Mon January 13, 2003 4:28pm
|
HiPo 289 with 3-2s
289 in '66 Mustang has seen 8,000 rpm and pulling strong. Old technology; dual breaker points, three 2Bbls and manual choke.
|
|
nikbj68
Fri August 22, 2003 3:17am
Rating: 5.5
|
Learning the finer points of the fly-off handbrake! 1989
|
|
nikbj68
Fri August 22, 2003 3:39am
Rating: 1
|
Gerry Bagshaw & Jon Minshaw discuss the finer points of Cobra detail.20
|
|
mloy
Sun March 13, 2005 12:32pm
Rating: 10
|
Front Pick-Up Points in Jig
|
|
mloy
Sun March 13, 2005 12:34pm
Rating: 10
|
Pick-Up Point Jig
Jig I built to hold the control arm pick-up points at the correct angle and position for welding.
|
|
computerworks
Wed May 4, 2005 8:35pm
Rating: 10
|
|
mloy
Sat July 16, 2005 2:00pm
|
Rear Spring Tower - 289 Leaf Spring
Rear spring tower and rear a-arm mount points
|
|
mloy
Sat July 16, 2005 2:00pm
Rating: 10
|
Rear Spring Tower - 289 Leaf Spring
Left side view of 289 rear leaf spring tower with rear a-arm mount points.
|
|
cobrajeff
Sun September 4, 2005 7:38am
Rating: 10
|
Passenger side impact bar
The forward-brace bar and side impact bar provide good lifting points to hoist yourself out.
Black foam pad on tunnel is removable, provides a cushion against sharp edges of bare aluminum tunnel.
|
|
cruzer5531
Tue December 27, 2005 7:06pm
|
front suspension
revised mounting points for 5" roll center. Still following CSX specs.
|
|
Morris
Sun December 24, 2006 7:20am
|
|
1985 CCX
Wed January 17, 2007 10:21am
Rating: 10
|
CCX Builders and Sales Points
|
|
FatBoy
Mon February 5, 2007 2:38pm
Rating: 10
|
Contemporary Chassis Details
This photo shows the mouting points for the roll bar prior to painting and assembly. The bracket high up on the outside of the right tube supports the outside leg, while the inside leg bolts to the two holes in the top of the cross-member.
|
|
1985 CCX
Tue April 24, 2007 5:09pm
Rating: 10
|
Installation of hoop portion of rollbar.
In process of rollbar installation. Bar was custom bent to 60's CSX specifications by Mickmate. Once the fishmouth is welded the tail portion of bar will be added. All bolt points are to frame making it functional via 0.120" wall tubing. Almost ready for paint and grommets.
|
|
