52chevyred
Fri January 1, 2010 7:49am
|
Street Beast Motor Mount "mistake"
Here is another "mistake" Street Beasts made on the motor mounts. Kurt the builder made new ones (on the right).
|
|
52chevyred
Fri January 1, 2010 7:50am
|
Street Beasts Driver Sidepipe
Here is the Street Beasts sidepipe on the driver side. Another lesson learned: if you use a 351W for mock up and are installing a 302, THERE IS A DIFFERENCE! The 302 is 2" narrower (at the head) and about 1" lower (at the head) than the 351. We had to "adjust" the motor mounts when I put the dummy 302 in.
|
|
B&B-Cobra
Sun January 17, 2010 6:37pm
|
09_013
Body back on, final wiring, windhshield mounts, roll bar
|
|
Wbulk
Wed March 24, 2010 7:56am
Rating: 10
|
Upper Shock Mounts
New Upper shock mounts being cut on Kirkhams water jet.
|
|
Wbulk
Tue April 13, 2010 5:37pm
Rating: 10
|
Modified B and B Suspension Mounts
This was to correct a defect on some cars sold in 2009. The lower tubes were raised to the proper position in the picture. The upper mounts were redesigned and raised to accept a longer shock. This corrected bump steer, roll center and shock travel issues.
|
|
krausewich
Sat June 5, 2010 9:46am
|
Rollbar mounts are now a go !
|
|
Wbulk
Fri June 11, 2010 5:56pm
Rating: 10
|
Upper Shock Mounts
New upper shock mounts tacked into place. These allow for a longer shock to be used.
|
|
krausewich
Sat June 12, 2010 5:49am
|
Simple E-brake mounts tightly accompanying the shifter.
|
|
krausewich
Sat July 10, 2010 7:22am
|
|
fastraxsg
Mon October 4, 2010 7:26pm
|
motor mounts
Had a serious problem with ground clearance so raised the motor up in the chassis and a tab forward to clear local monster speed bumps and deep potholes.
|
|
kitcarbp
Wed October 20, 2010 6:31am
Rating: 10
|
west coast windshield mounts
west coast windshield mounts
|
|
Jac Mac
Tue April 12, 2011 10:35pm
Rating: 10
|
9 inch Ford Independent rear center section.
9 inch Ford Diff assy, mounts on 4 pads on rear of housing plus 'ring' bracket that attach's to pinion retainer. This particular unit has now completed seven hard seasons of classic racing in a TVR Tuscan. We are now upgrading the axle shafts to 35 spline to make it totally bulletproof...if such a state ever exists!:)
|
|
CobraMan2011
Sun July 31, 2011 8:03am
|
Joel's last build
first attempt at setting in the 473 big block to fab motor mounts, etc.
|
|
frdfver
Thu September 8, 2011 3:33pm
|
NAF Build
Working out the mounts and hose routing for the remote filter, oil thermostat and cooler. Final clamping and etc. later.
|
|
frdfver
Thu September 8, 2011 3:33pm
|
NAF Build
Working on getting the belts positioned and mounted. Got to build the mounts in the trunk area and mod body in wheelwell area.
|
|
