MrMagoo
Sun November 25, 2007 10:29am
Rating: 1
|
Engine Removal (2)
Wow, now I have room for a second passenger...
|
|
Silverback51
Sun July 13, 2008 6:50am
Rating: 10
|
|
RJCCOBRA
Tue November 25, 2008 2:59pm
|
Shell Valley build
Rear roll bar down legs were notched and fitted. The first one was the hardest. After the correct angle and length were determined, the second one was a breeze. Good thing, since we broke Buddy's 2 inch hole saw while finishing the notch on the second down leg.
|
|
RJCCOBRA
Fri December 12, 2008 3:03pm
|
Shell Valley build
The first coat of paint has been sprayed in the engine compartment. After it drys, it will be sanded and a second coat applied. I may have to do 3 or 4 coats to get it where I'm satisfied.
|
|
RJCCOBRA
Sun December 14, 2008 1:49pm
|
Shell Valley build
This is the firewall after its second coat of paint.
|
|
brent110672
Thu January 29, 2009 4:04am
Rating: 10
|
|
Danr55
Sun March 1, 2009 5:05pm
Rating: 10
|
Hooters Car Show
Second Place. A lot!
|
|
HI Cobra
Mon April 13, 2009 9:19pm
Rating: 10
|
This is why I like to go to my second home in Texas!
|
|
Dwight
Wed October 14, 2009 8:09am
Rating: 10
|
Ed Combs DVSF IV
Ed 90 seconds after 40 plus Cobras blast by
|
|
pgermond
Sun November 1, 2009 4:34pm
Rating: 10
|
Mather Auto-X
The Mustang turned in the fastest time of the day, with the Cobra being second.
|
|
Tom Kirkham
Tue December 1, 2009 11:53am
|
Holley carb tuning
Adjusting up the secondary butterflies
|
|
Tom Kirkham
Tue December 1, 2009 11:53am
|
DSC03595_Large_
adjusting up the secondaries
|
|
hogster
Sat June 5, 2010 3:02am
|
Stainless welding
Used the Henrob Oxy/Acetylene torch to have a go at 316 stainless. Not a bad effort for second try.
|
|
terlingua71
Fri October 28, 2011 11:33am
Rating: 10
|
Terlingua Cobra the second of the six produced
|
|
nanard289
Fri December 30, 2011 1:35pm
Rating: 10
|
Building operation - second step
here I cut a 90° aluminum pipe elbow to have two small 40° elbow. This will allow to have a vertical 5° angle
|
|
