JCoop
Mon June 26, 2006 7:22am
Rating: 10
|
48IDA Webers Under GT40 glass
Too bad the anti-reversionary plates hit the glass when fitted. They don't look too bad without them, though; especially with those Inglese filters. The rearmost stack is just about 1.5" below the glass.
|
|
427SnakeSC
Wed July 25, 2007 11:30am
Rating: 10
|
|
ddcobra
Fri January 25, 2008 5:36am
Rating: 10
|
|
ddcobra
Fri January 25, 2008 5:36am
Rating: 10
|
|
ddcobra
Fri January 25, 2008 5:36am
Rating: 10
|
|
cobrajam
Sun February 10, 2008 6:56pm
|
Right Inner Wheelwell Clearanced for Larger Tires
Optional 'bubble' added to Midstates body to clear larger tires. Almost looked like a hoodscoop stood on end. They cut out section behind seats and simply glassed this in. Appears to offer plenty of clearance for the 335/35 ZR17s I am using
|
|
RJCCOBRA
Thu November 13, 2008 3:17pm
|
Shell Valley build
The cowl hoop & windshield are mounted, and drivers side rear wheel well sectioned for tire clearance. I don't know what jig Shell Valley used to align the interior tub to the body, but it was way off. I'll probably have pictures of the fiber glassing effort later.
|
|
RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
RJCCOBRA
Fri January 23, 2009 2:43pm
|
Shell Valley build
Here's the hood after we straightened it and put the first layer of glass cloth on the inner panel.
|
|
HighPlainsDrifter
Thu March 26, 2009 8:54am
Rating: 10
|
bodywork scoops glassed in
|
|
kitcarbp
Mon April 13, 2009 6:36am
Rating: 10
|
Modified Lower Radiator Hose
Here is the modified lower hose to keep the surge tank on the LOW pressure side (water pump inlet) of the system. Not the most elegant but very functional. I found a glass filled nylon "T" taht is 1.75" and has a 1.0" fill line for the surge tank.
|
|
mickmate
Mon July 20, 2009 7:15pm
|
Jacks Hi Tech
Hi Tech with glass body and aluminum hood trunk and doors. What a beauty.
|
|
Z-linkCobra
Mon November 2, 2009 11:08am
|
Dash and center console.
Once all the foam work is done and shaped...then all of it will get glassed in to the body. Making the dash, console and doors all one peice.
|
|
Wbulk
Sun December 27, 2009 10:44am
Rating: 10
|
Switch Bracket for Fiberglass Dash
Design of Ignition Switch Bracket to keep the switch from turning in a fiberglass dash. The corners of this are glassed in to the back of the dash with kitty hair fiberglass filler.
|
|
Wbulk
Sun December 27, 2009 10:44am
Rating: 10
|
Switch Bracket for Fiberglass Dash
Switch Bracket to keep the switch from turning in a fiberglass dash. The square corners of the bracket are glassed in to the back of the dash with kitty hair fiberglass filler.
|
|
