FST FOX
Fri September 21, 2007 8:38pm
Rating: 10
|
|
FST FOX
Fri September 21, 2007 8:38pm
Rating: 10
|
|
FST FOX
Fri September 21, 2007 8:38pm
Rating: 10
|
|
CSX3018
Wed December 5, 2007 7:28am
Rating: 10
|
R.H.M. CSX3018 Factory comp. car
SCCA Race Wilmont Hills Wis. 1966
|
|
martrogers
Fri February 29, 2008 9:42pm
|
Bonnet Lip Milling Tool
The bonnet lip was variable thickness which made fitting a seal rubber difficult. This tool was lashed up by fixing a metal guide to a drill with Jubilee clips and using a milling bit. Worked very well as can be seen form the amount of fibreglass swarf.
|
|
lovehamr
Mon May 12, 2008 6:34pm
Rating: 10
|
|
lovehamr
Mon May 12, 2008 6:34pm
Rating: 10
|
|
Sinjin
Thu June 18, 2009 5:00pm
Rating: 10
|
Watts Linkage
Details of Swing Arm Fixing
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ac4
Logo in position, just need to remove tape and fix from the underside (which means taking out radiator, draining down etc)
|
|
fkemmerer
Sat October 10, 2009 4:15pm
Rating: 10
|
Oil Temperature Sensor Insulation
Simple fix to insulate the oil temperature gauge sensor on the front of my oil pan.
|
|
52chevyred
Fri January 1, 2010 7:49am
|
Street Beasts Rollbar "mistake"
Here is another "mistake" Street Beasts made in locating the rollbars. Kurt fixed it later.
|
|
52chevyred
Fri January 1, 2010 7:54am
|
Rollbar 3rd Leg Problem
Here, Street Beasts made another "mistake" on the 3rd leg bracket. Kurt the builder fixed it later
|
|
52chevyred
Fri January 1, 2010 7:54am
|
Rollbar 3rd Leg Fixed
Here, Kurt the builder fixed the problem by relocating the bracket
|
|
Wbulk
Fri May 7, 2010 11:44am
Rating: 10
|
Ball Joint Seal Ring
This is a Fix for A Arms that use the Chrystler ball joint without a seal groove machined in. This one was from B and B. A 3/16" steel ring was added to accept the ball joint seal. It was tack tig welded on the outside edges. The rings were cut on a water jet by Kirkhams Motorsports. Barry McGill can also do the fix.
|
|
Wbulk
Sun May 9, 2010 9:03am
Rating: 10
|
Ball Joint Seal Ring
A fix for A Arms shipped without the ball joint seal groove machined in. Ring added to accept a Chrystler Ball Joint Seal. The 3/16" thick rings were cut on Kirkhams Motorsports water jet. Barry McGill can also do the fix. The bad thing was B&B sent me the wrong arms that I paid to get fixed.
|
|
