TWOOD
Tue August 26, 2008 6:42am
Rating: 10
|
Control arm and bracket attached to frame
I assume that this is the correct way to mount hese brackets.
|
|
n6opv
Thu January 22, 2009 11:23pm
|
Arntz tranny tunnel
Shown here is the removable section of the tranny tunnel. With the big engine setback in all the Arntz / Butler cars, you can remove the transmission while seated if you desire. Only a few very late Butlers had this and all Arntz Type 4 cars. I have no idea what the many cutouts are for  Also shown are the two triangulation tubes that connect the center of the cowl hoop to the 2 main frame rails for increased rigidity. The 3rd leg of the roll bar (not shown) also attaches to the same point on the passenger side frame rail. This is Arntz Type 4 only as well.
|
|
DocDirk
Thu February 12, 2009 9:28pm
|
Unusual rear attachment
Seems this setup won't allow any suspension travel at all...??
|
|
DocDirk
Wed April 8, 2009 7:27pm
|
Opposite side rear attachment of lower arm.
Doesn't look like it's going to allow much vertical movement either...given the square end of the link in a square receptacle...
|
|
DocDirk
Wed April 8, 2009 8:38pm
|
Right rear lower link arm at axle
Rotated view of rear lower link arm right side showing square link arm attached inside a square receptacle on the axle...very little or no room for rotaion with axle movement.
|
|
Austin_Snake
Thu April 9, 2009 7:36am
Rating: 10
|
Exact 427 belt attachment
Bolt on Roll bar seat belt attachment
|
|
Austin_Snake
Thu April 9, 2009 7:36am
Rating: 10
|
Exact 427 Belt attachment
Welded roll bar seat belt attachment
|
|
DocDirk
Tue May 5, 2009 7:44pm
|
|
vector1
Thu June 4, 2009 5:08pm
|
|
cobbindale
Sun September 13, 2009 3:28am
Rating: 10
|
Paint protection
Clear protective paint film applied applied to nose and front of car
|
|
cobbindale
Sun September 13, 2009 3:28am
Rating: 10
|
Paint protection
Clear protective paint film applied.
Barel visible line from mid headlight to mid leading edge of gaurd.
|
|
cobbindale
Sun September 13, 2009 3:28am
Rating: 10
|
Paint protection
Clear protective paint film applied to complete from section of car
|
|
smallblockhead
Sat December 19, 2009 9:52am
Rating: 10
|
|
Z-linkCobra
Thu February 18, 2010 8:25am
|
Trunk hinge support
When I got this kit the trunk lid and hood were not attached to their frames. So before joining the two together I figured I would give the hinges something solid to bolt to...and also add some strength. The holes are 5/8 and I am making some press fit threaded collars to put in the holes for 3/8 bolts.
|
|
289ACE
Sat April 3, 2010 8:29pm
Rating: 10
|
Prop rod attachement to inner fender
|
|
