Todd Hedges
Fri February 15, 2002 3:39pm
|
ERA CAR 611
Jag Rearend with 3.07:1 limited slip.
Custome ERA carrier with outboard brakes.
4 piston Serra Fonrt brakes w/12-1/8" vented Rotors.
|
|
CCX33911
Tue June 11, 2002 11:57am
Rating: 10
|
Contemporary Brakes New vs Old
Brembo 14" Rotors on Custom Hat for Contemporary Cobra
|
|
Venom S
Tue July 16, 2002 1:16pm
|
|
Anthony installs the Wilwood 6-piston calipers on the 13" 2-piece Wilwood rotors
|
|
JT
Wed August 28, 2002 3:07pm
|
Nice rotors!
A shameless "plug" for Edelbrock wheels. A nice substitute for Halibrands at a fraction of the cost.
|
|
speed220mph
Fri July 11, 2003 6:39am
|
Mustang Rear disc brakes
Original rear drums replaced with T-Bird/Cougar rear disc brakes and grooved rotors. Lowering blocks, sway bar and Bilstein shocks used.
|
|
Morris
Fri July 23, 2004 7:57pm
Rating: 10
|
KMP 259
13" Rotors and Wildwood GN 6 piston Calipers
|
|
Morris
Fri July 23, 2004 8:10pm
Rating: 10
|
KMP 259
Right Front Upright for 13" rotors and GN 6 Piston Calipers
|
|
bshap
Thu April 21, 2005 4:03am
Rating: 8
|
Estate sale
Here is a beautiful NEARLY NEW 1983 Cobra. Properly and carefully built from a WEST COAST COBRA kit, it is fitted with a Ford 460ci V8 engine. This beast has only gone approximately 8000 miles since completion. Always stored inside. The builder/collector/owner recently passed away and this is an estate sale. It has a Nascar Can-Am chassis with power rack and pinion steering; 11-inch vented rotors with 4-piston racing calipers; 4-bar rear axle with 9-inch drop-out center section; 25 gallon race-legal fuel cell; weight 2970lbs (50/50 front/rear). Available with or without a spare fully-rebuilt 460ci engine. Located near Toronto Canada. Pre-purchase inspections and/or appraisals are welcome. Hard to find a nicer example! Asking cdn$56,000.00 (us$45,000) OBO Contact Bob Shapton 519-927-3966
|
|
66rdster
Mon September 26, 2005 5:14pm
|
|
Engineer Ed
Sun October 2, 2005 6:17pm
|
What's wrong with this picture?
Broken rotors during track event / Gainesville 2005.
Now that is super braking power!
|
|
mickmate
Wed October 25, 2006 7:44pm
Rating: 10
|
Laser cut rotor hats
Programmed and laser cut these to fit my 6 pin to Wilwood rotors
|
|
mickmate
Wed October 25, 2006 7:44pm
Rating: 10
|
Laser cut rotor hats
Programmed and laser cut these to fit my 6 pin to Wilwood rotors
|
|
