fastraxsg
Thu April 2, 2009 8:07pm
Rating: 6
|
Tank
Modified filler for Hurricane stock tank
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Bogged
Filler done. Almost ready for hi fill
|
|
cobbindale
Wed April 29, 2009 10:02pm
Rating: 10
|
Filler in doors
Body filler in doors, cowling and sills
|
|
hogster
Sat June 27, 2009 11:06pm
|
Added Filler Rod
Same procedure with the filler rod
|
|
KarlCSX2498
Tue August 4, 2009 9:02am
Rating: 6
|
Fuel filler port, installed by Nick at Acton Custom
A very nice install by nick, fully TIG welded on the inside. A perfect job.
|
|
martrogers
Fri October 2, 2009 11:59pm
|
ackit
Pic showing the drilling template with 2 holes drilled. In the background is a template I made by putting cling film on the bonnet, and getting the curve into body filler. This mould template was then used to ensure the AC would fit the curve of the bonnet.
|
|
Wbulk
Mon December 7, 2009 5:10pm
Rating: 10
|
Gas Filler Modification
Modification to a B and B fuel filler. It is just setting in place. The LeMans cap still has to be drilled.
|
|
Wbulk
Mon December 7, 2009 5:14pm
Rating: 10
|
Fuel Filler Modification
Pieces for the Modified B and B Fuel Filler.
|
|
Wbulk
Sun December 27, 2009 10:44am
Rating: 10
|
Switch Bracket for Fiberglass Dash
Design of Ignition Switch Bracket to keep the switch from turning in a fiberglass dash. The corners of this are glassed in to the back of the dash with kitty hair fiberglass filler.
|
|
Wbulk
Sun December 27, 2009 10:44am
Rating: 10
|
Switch Bracket for Fiberglass Dash
Switch Bracket to keep the switch from turning in a fiberglass dash. The square corners of the bracket are glassed in to the back of the dash with kitty hair fiberglass filler.
|
|
fastraxsg
Tue December 29, 2009 6:55am
|
trunk_tub
Top fill for gas tank, fills from inside trunk. Too easy for stones and such in the gas tank or someone to borrow fuel with LeMans filler. Outside cap will be for show only.
|
|
FUNFER2
Sat February 6, 2010 5:41am
Rating: 10
|
Polished 304 stainless steel side pipes."Gilmore Kit"
Turn out. Notice how it slides between the muffler & muffler housing, for a nice tight & clean fit. Requires only a small tig weld. Use filler rod if you wish to smooth the weld.
|
|
Rebel1
Thu May 27, 2010 6:14pm
|
|
Rebel1
Fri May 28, 2010 4:14am
|
unleaded fuel filler insert
|
|
kitcarbp
Thu October 14, 2010 7:24am
Rating: 10
|
Rear Fender Fuel Filler Neck Mock-up
custom filler neck using 68 Mustang Repro parts.
|
|
