RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
RJCCOBRA
Fri January 23, 2009 2:43pm
|
Shell Valley build
Here's one more look at the license plate bracket.
|
|
RJCCOBRA
Fri January 23, 2009 2:43pm
|
Shell Valley build
Here's the hood after we straightened it and put the first layer of glass cloth on the inner panel.
|
|
07cob
Mon January 26, 2009 8:54pm
Rating: 10
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
|
Shell Valley build
Installed the trunk prop rod today.
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
|
Shell Valley build
Got the hood prop rod fabricated and installed. I used a piece of 5/16 inch OD 304 stainless and a stainless sherical rod end.
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
|
Shell Valley build
Passenger side door latch assembly is installed. We had to cut and reglass a portion of the fender well to get clearance for the striker plate.
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
Rating: 1
|
Shell Valley build
Here's the driver's side door latch assembly installed.
|
|
RJCCOBRA
Thu January 29, 2009 3:22pm
|
Shell Valley build
After 20 years, we finally got the title and plates for the Shell Valley.
|
|
RJCCOBRA
Wed February 4, 2009 3:01pm
|
Shell Valley build
We had to relocate the rear license plate light and bracket so that the license plate would clear the trunk handle.
|
|
RJCCOBRA
Wed February 4, 2009 3:01pm
|
Shell Valley build
Here's another shot of the trunk lid with the mounting point for the license plate light raised by 1 inch.
|
|
RJCCOBRA
Wed February 4, 2009 3:01pm
|
Shell Valley build
This is a shot of the light and bracket installed in the new, raised location.
|
|
RJCCOBRA
Thu March 26, 2009 2:49pm
|
Shell Valley build
Rollbar and rear bumper installed
|
|
kitcarbp
Fri March 27, 2009 10:17am
Rating: 10
|
Edelbrock/Ford SVO 429/460 Pump Flow Chart
Here is a chart I put together that compares the two different popluar pulley sizes available in the aftermarket for the 429/460 in fancy shmancy polished powder coated clear aluminum pulleys. The big pulley is not the way to go, you cant get enough flow to cool these high horsepower motors on the street.
|
|
Cobra Tracks
Fri September 25, 2009 7:12am
|
|
