cobrajeff
Sun November 21, 2004 6:37am
Rating: 10
|
Weber Float Level
Using tools to measure float level. Spring to hold float in "up" position not shown.
|
|
cobrajeff
Sun November 21, 2004 12:08pm
Rating: 10
|
351C Weber intakes
High-Port manifold on right. Note vacuum holes on inboard side, as opposed to th eold intake, where they were outboard.
Two bosses on intake for "hard" linkage, as opposed to th e"cable" linkage of the Pantera system.
|
|
cobrajeff
Sun November 21, 2004 12:19pm
Rating: 10
|
351C Port Plates
351C 4V intake on top; 351C SVO "High-Port" intake on bottom. Note how MPG intake side "port plates" would reduce 4V port openings to the same size as SVO high-ports (!).
|
|
MOTORHEAD
Sat December 11, 2004 7:30pm
Rating: 9
|
A new bonnet and we're good to go !! NOT !!
|
|
Michael C Henry
Mon December 13, 2004 8:51pm
Rating: 10
|
defroster_vents
I installed the vents as far back as possible notict windsheild tensioner
|
|
Michael C Henry
Mon December 13, 2004 9:19pm
Rating: 10
|
new_carb_part
notice in the square primaries, lower ventury, the little brass tube sticking out at about 7 o'clock.What is it for?
|
|
Michael C Henry
Mon December 13, 2004 9:55pm
Rating: 10
|
new_stuffed
I do not have much space to spare
|
|
Michael C Henry
Mon December 13, 2004 10:12pm
Rating: 10
|
new_tunnel_and_dash
Now I can get some help with transmission and not remove shifter linkage
|
|
Michael C Henry
Tue December 14, 2004 9:00am
Rating: 10
|
Drivers_left_thigh_rest
not my idea but it works great same height as hinge .lets left thigh brace off of it
|
|
Michael C Henry
Tue December 14, 2004 9:23am
Rating: 10
|
top_rt_foot_box
Holley dead end fuel pressure regulater Y .Old wiper motor didn't self park . Voltage regulater and starter soleoid gave up when system was changed. The outside head stud w/Dove rocker anchor for shaft end support. Notice heat sheild thin aluminum and 1/2" thich foam w/ foil inside layer
|
|
Michael C Henry
Tue December 14, 2004 12:06pm
Rating: 10
|
new removable tunnel cover
I made this removable transmission tunnel cover so i could have help with the transmission removable and reinstallation and not have to remove shift linkage
|
|
Michael C Henry
Tue December 14, 2004 12:13pm
Rating: 10
|
padded dash
Fresh vinyl covered EM steel dash w/glove box I installed the glovebox.I didn't open up the holes for the large gauges enough.I have to lube the tach and speedo to remove or install. dash mounted Flaming River master switch not installed yet.
|
|
Michael C Henry
Wed December 15, 2004 9:41pm
Rating: 10
|
thin manifold flange perimiter
Notic how thin the perimiter wall is
|
|
Michael C Henry
Wed December 15, 2004 9:47pm
Rating: 10
|
secondary float notched to clear jets
notched float to clear replacable jets .Supplied and prepaired by Quick Fuel Technology
|
|
Michael C Henry
Wed December 15, 2004 9:54pm
Rating: 10
|
primary side of main body of acarb
notice the little replaceable orifaces
|
|
