c_forshaw
Sat May 4, 2002 8:21am
Rating: 10
|
|
Mike Lopez
Sun November 17, 2002 4:48pm
|
side pipe mods
These are some mods I made to my headers,sounds good and no leaks
|
|
Rick Bagley
Thu January 23, 2003 3:24pm
Rating: 10
|
Test Run
Test Run, Getting some engine time, and checking for leaks. 427 SO, 4 speed toploader.Unique
|
|
Cobra20646
Tue July 1, 2003 4:23am
Rating: 10
|
"PROFUEL"
A very stout glass type fuel filter. No plastic parts to break and cause the thing to leak. The only plastic used is the 'cage' for the filter material.
|
|
daleed
Fri September 19, 2003 11:30am
Rating: 1
|
Oil Leak
Plugs were not tight from the builder
|
|
rms427
Thu January 29, 2004 7:16pm
Rating: 10
|
|
Jetlaag
Fri April 2, 2004 8:26am
|
oops.. Rear diff. seals are leaking...
|
|
Michael C Henry
Wed December 15, 2004 10:20pm
Rating: 10
|
channel epoxied in
iIepoxied in the unused channel on primary side,it wasn't drilled though but leaked vacume outside the manifold flange perimiter. the vacume nipple is functunal and notice the power valve blow out protection
|
|
Michael C Henry
Wed December 15, 2004 10:22pm
Rating: 10
|
epoxied carb base plate
I thought i did a good job epoxing in the unused channels that leaked vacume
|
|
Secret Squirrel
Tue December 21, 2004 8:26am
Rating: 10
|
Cool Down After First Road Test
Engine after 1st road test around the neighborhood. Cool down and leak inspection, 12/19/2004.
|
|
HSSS427
Wed July 20, 2005 2:25pm
|
Tremec 3550 vent?
This pop attachment on top of the Tremec doesn't show up on the diagram. Is it a vent and could it be the source of a fluid leak - see picture below vent. If so, why and how do I correct it?
|
|
