Shelboss
Thu February 28, 2008 8:54am
|
Contemporary Cobra Watts linkage
Pivot point added to stock Jag hubs
|
|
Rudolph Hucker
Mon June 23, 2008 2:23pm
Rating: 10
|
|
taylor-played
Tue August 26, 2008 10:24am
|
Pedals and footbox After
Moved the support brace back to openup footwell... added Wilwood and Lokar pedals and hydraulics...
|
|
RJCCOBRA
Wed January 21, 2009 3:46pm
Rating: 1
|
Shell Valley build
The hood was bowed and warped so badly that we had to cut slots in the inner panel, fill with foam, and then add weight to level out the passenger's side. After the foam hardened, we put a layer of glass over the cuts and added weight again.
|
|
Bernica
Wed February 25, 2009 12:15pm
Rating: 10
|
IMG_2618_Medium_
Added fuel level gauge (on right)
|
|
Baz
Fri March 13, 2009 1:22am
Rating: 1
|
My selected colour
Known as Turismo. I have added heaps of pearl.
|
|
Baz
Fri March 13, 2009 1:22am
|
Stripe colour and design.
A Landrover colour known as Zambezi Silver, but with heaps of Special Effects Silver added.
|
|
hogster
Sat June 27, 2009 11:06pm
|
Added Filler Rod
Same procedure with the filler rod
|
|
cobrajeff
Tue December 22, 2009 8:07am
Rating: 10
|
Air screen added in front wheel house
|
|
cobrajeff
Tue December 22, 2009 8:07am
Rating: 10
|
Heat shields added
I glued 3/4" foam insulation to the floorboards, and then sealed it off with sheet aluminium.
|
|
cobrajeff
Tue December 22, 2009 8:12am
Rating: 10
|
Electric Fuel Pump Inertia Cut-off Switch
Added an inertia switch to my Holley electric fuel pump
|
|
cobrajeff
Wed December 23, 2009 7:22am
|
Rear wheel
My GoodYear Gatorbacks with white lettering and blue stripes added
|
|
52chevyred
Mon May 3, 2010 3:35pm
|
Street Beasts Inner Fenderwell Installed
Just a shot of the inner fenderwell installed: really added strength to the body. The side vent is cut out too.
|
|
Wbulk
Fri May 7, 2010 11:44am
Rating: 10
|
Ball Joint Seal Ring
This is a Fix for A Arms that use the Chrystler ball joint without a seal groove machined in. This one was from B and B. A 3/16" steel ring was added to accept the ball joint seal. It was tack tig welded on the outside edges. The rings were cut on a water jet by Kirkhams Motorsports. Barry McGill can also do the fix.
|
|
Wbulk
Sun May 9, 2010 9:03am
Rating: 10
|
Ball Joint Seal Ring
A fix for A Arms shipped without the ball joint seal groove machined in. Ring added to accept a Chrystler Ball Joint Seal. The 3/16" thick rings were cut on Kirkhams Motorsports water jet. Barry McGill can also do the fix. The bad thing was B&B sent me the wrong arms that I paid to get fixed.
|
|
