cobrajeff
Wed March 23, 2005 9:26am
Rating: 10
|
Plastic Valve Covers
Here are two sets of plastic COBRA valve covers I made in the 70's. Thought the clear ones would really be cool. To really get the detail, I would have had to drill small air holes in them to get the vacuum machine to work well - I wasn't willing to do that.
|
|
simon clemens
Wed April 27, 2005 7:24am
|
Brake relocation
Rear brake relocation was needed to allow clearance between the coilovers and the calipers. Re-drilled calliper mount bracket holes so the caliper sits about 40 degrees foward from original position. Also had to swap Left & Right brake assemblys to opposite sides, so the hand brake cable now will run on top of the axle & still be accuated by a foward movement. I wonder if others have thought of this solution?
|
|
RobV
Mon June 13, 2005 7:26pm
|
Using Power Point in lieu of AutoCad
Since I only have AutoCad at work and I need a templete for the spacing of the holes in the gas cap mounting, I used Power Point. Three circles and a pentagon gave me a location to center punch for my mounting bolt holes.
|
|
simon clemens
Mon July 18, 2005 8:11am
Rating: 10
|
Dash holes
cutting the holes for the dash components
|
|
simon clemens
Mon October 31, 2005 6:14am
|
Boot Hinges SS
Marking the location for the polished stainless steel boot hinges. Aligned the boot lid with spacers and held into place with 2"
packing tape, before drilling holes.
|
|
GARK
Mon November 28, 2005 1:29pm
|
|
Jbb
Tue January 3, 2006 6:48pm
|
|
Herkypilot
Sun February 5, 2006 1:43pm
|
|
simon clemens
Mon February 27, 2006 7:52am
|
|
Rick 427 Cobra
Sat May 27, 2006 4:23pm
Rating: 10
|
replacement plate with holes
|
|
Sydney
Fri June 2, 2006 12:10am
|
|
Morris
Mon October 30, 2006 8:04pm
Rating: 8
|
Vent holes for vent lines
|
|
Morris
Fri December 8, 2006 6:44pm
|
No holes in the side for Seat Belts
|
|
FatBoy
Mon February 5, 2007 2:38pm
Rating: 10
|
Contemporary Chassis Details
This photo shows the mouting points for the roll bar prior to painting and assembly. The bracket high up on the outside of the right tube supports the outside leg, while the inside leg bolts to the two holes in the top of the cross-member.
|
|
Terry Stapley
Thu August 16, 2007 2:54pm
Rating: 10
|
2007UCCcruise16
2007 Cruise Utah - Scenery - The holes are almost the same
|
|
