FUNFER2
Sat February 6, 2010 5:18am
Rating: 10
|
Hanger
This hanger has a weld tab that is shaped to fit the muffler housing and with the supplied bolts, is adjustable.
|
|
FUNFER2
Sat February 6, 2010 5:30am
Rating: 10
|
Polished 304 stainless steel "Gilmore Kit" Stars & points.
Stars & points welded to primaries. Now ready to be installed into the collector.
|
|
FUNFER2
Sat February 6, 2010 5:36am
Rating: 10
|
Polished 304 stainless steel pipes. "Gilmore Kit".
Collector into muffler. Notice how the collector slides between the muffler & muffler housing, for a nice tight & clean fit. Requires only a small tig weld.
|
|
FUNFER2
Sat February 6, 2010 5:41am
Rating: 10
|
Polished 304 stainless steel side pipes."Gilmore Kit"
Turn out. Notice how it slides between the muffler & muffler housing, for a nice tight & clean fit. Requires only a small tig weld. Use filler rod if you wish to smooth the weld.
|
|
hogster
Sun May 2, 2010 9:43pm
|
Sidepipes 1
Stainless flanges completed ready for welding
|
|
Wbulk
Fri May 7, 2010 11:44am
Rating: 10
|
Ball Joint Seal Ring
This is a Fix for A Arms that use the Chrystler ball joint without a seal groove machined in. This one was from B and B. A 3/16" steel ring was added to accept the ball joint seal. It was tack tig welded on the outside edges. The rings were cut on a water jet by Kirkhams Motorsports. Barry McGill can also do the fix.
|
|
BeasleyRB
Sun May 9, 2010 9:39am
|
Oil Pan Protection
Plate welded on bottom of oil pan
|
|
BeasleyRB
Sun May 9, 2010 9:39am
|
Oil Pan Protection
Plate welded on bottom of oil pan
|
|
hogster
Sat June 5, 2010 3:02am
|
Stainless welding
Used the Henrob Oxy/Acetylene torch to have a go at 316 stainless. Not a bad effort for second try.
|
|
hogster
Sat June 5, 2010 4:05pm
|
Henrob Vs Stainless
Stainless offcuts welded with oxy/acetylene
|
|
Wbulk
Fri July 16, 2010 1:32pm
Rating: 10
|
Rear Bumper Modification
Completed modication with the welded on bracket on the end of the tubes cut off and bolts going through to the frame bracket.
|
|
lamaluv
Wed October 20, 2010 6:08pm
|
phpYepJV5PM
Rear welded tie down loops
|
|
Zedn
Sun November 28, 2010 1:33am
|
|
Outwest34au
Fri December 10, 2010 2:18pm
Rating: 10
|
Door intrusion bar
Welded in
|
|
Outwest34au
Fri December 10, 2010 2:18pm
Rating: 10
|
Door intrusion bar
Welded in
|
|
